EMC-KEL-DS | Split EMC cable entry frames
for shielding cables with connectors / IP55
The EMC cable entry frame EMC-KEL-DS has been metallised (galvanise coated) to create a conductive surface.
The front cable grommet (KT) is used for strain relief and cable sealing on the cable jacket. The cable shield is contacted over 360° via the rear conductive grommet (EMC-KT).
The EMC-KEL-DS frames match exactly the cut-out dimensions for 24-pin standard industrial connectors. Either a cut-out of 36 mm or 46 mm in height can be chosen depending on the cables being routed.
The contact between the EMC-KEL-DS and the conductive housing wall is realised via the included conductive flat gasket.
It is also possible to integrate threaded bushings. Please ask us about your desired variant. The version with threaded bushings enables the cable entry frame to be screwed onto the housing from the inside out. This protects against vandalism and tampering with the housing from the outside.
Part No.
99411
Specifications
Temperaturbereich Range Max
140 C°
Flame class
UL94-HB
Temperaturbereich Range Min
-40 C°
Advantages and benefits
Both conducted and field-bound disturbances can be reliably diverted
Strain relief and sealing are separated from the EMC contact
Scratch-resistant surface
Contacting the cable shield over 360°
EMC grommets made entirely from conductive elastomer
Very good dissipation values
Very good shielding effect with regard to EMC tightness
Product variants and sizes
EMC-KEL-DS 24|7
Number
99411
EAN
4251269322686
Packaging Unit
Unknown
Cut-out size
112 × 36 mm
EMC-KEL-DS 24|4
Number
99412
EAN
4251269322693
Packaging Unit
Unknown
Cut-out size
112 × 36 mm
EMC-KEL-DS 24|10
Number
99410
EAN
4251269322679
Packaging Unit
Unknown
Cut-out size
112 × 36 mm
The EMC cable entry frame EMC-KEL-DS has been metallised (galvanise coated) to create a conductive surface.
The front cable grommet (KT) is used for strain relief and cable sealing on the cable jacket. The cable shield is contacted over 360° via the rear conductive grommet (EMC-KT).
The EMC-KEL-DS frames match exactly the cut-out dimensions for 24-pin standard industrial connectors. Either a cut-out of 36 mm or 46 mm in height can be chosen depending on the cables being routed.
The contact between the EMC-KEL-DS and the conductive housing wall is realised via the included conductive flat gasket.
It is also possible to integrate threaded bushings. Please ask us about your desired variant. The version with threaded bushings enables the cable entry frame to be screwed onto the housing from the inside out. This protects against vandalism and tampering with the housing from the outside.